Techgsmnet

adnanali · 03-31-2009, 06:43 AM

Cyclone Box is a brand new tool for flashing .

a brand new tool for flashing and servicing of the latest Nokia BB5, DCT-L, DCT4, DCT4+ cell phones.
Features;

* USB BUS powered only, current in idle is 55mA
* World's first flexible configurations via software. It can be used TX2 pin on any RJ48 output i/o pin.
* First in the world built-in 10 pin diagnostic service for measuring phone damages via: voltage, current, frequency, STI BUS
* High speed flasher, real BUS speed up to 10-11Mbit, using 2 data lines
* UFS/JAF compatible pinout
* Switchable VPP - externally or internally generated signal, high speed flashing/erasing
* Advanced self-testing system
* Supports both FLASHBUS and USB connections for Nokia phones
* Built-in secure smart-card
* Cyclone Box uses it's own Smart Card and FTDI drivers so there are no conflicts with other devices
* Free 100 ASK-RPL credits are included into Cyclone Box pack to perform RPL calculation for Nokia DCT4 and DCT4Plus. The user does not need to wait for ASK-RPL online calculation.

Features

* Flash software (upgrade/downgrade)
* Reset SP SIM locks
* Lock phone to any network
* IMEI repair for the latest models
* Flash Bluetooth
* Save user settings
* Full factory (UI) defaults
* Software upgrade defaults
* Reset user lock (security code)

Quote:

SERVICE socket
(10 pin layout)
1 - BOX GENIO1
2 - VBAT (5v)
3 - BOX GENIO2
4 - BSI
5 - BOX RX_1
6 - BOX TX_1
7 - MBUS
8 - GND
9 - VPP
10 - BOX GENIO3

As you can see, pinout is compatible with UFS/JAF and other common Nokia boxes. For DCT4 you can plug directly UFS/JAF cables without any adapter. With BB5, most 8-pin market cables have TX2 instead VPP Pin. Our box don't have connected data line to VPP - only to power IC.
Tx2 might be changed ON THE FLY to any of GENIO pins (in further updated maybe also possible 100% flexible pinout modification, so ALL cables on markets will be supported!).
Bundled adapter crossing pin 3 with 9. That means on output from adapter, on pin 8 you will have TX2 (service pin 3) and still compatibility with UFS/JAF cables will be. VPP is not cutted. It's on pin nr 3 (unused pin nr 2 - jaf/ufs cables) so still VPP funcionality can be used on 8 pin cables, instead of purchasing 10 pin! With small mods needed, of course.
You can use too native 10pin Cyclone cables, but they are not avaiable on market at moment.

DIAGNOSTIC socket
1 - VBAT (5v)
2 - USART CLK
3 - USART TXD
4 - FREQ_MEASURMENT_A0
5 - FREQ_MEASURMENT_CLK
6 - DIAG_1_VOLTMETER
7 - DIAG_2_VOLTMETER
8 - DIAG_3_VOLTMETER
9 - USART RXD
10 - GND

Box + BB5 adapter to use with native jaf/ufs cables

cyclone box has a good feature
SERVICE socket and DIAGNOSTIC socket.

Thread Tools
Show Printable Version Email this Page
Display Modes
Switch to Linear Mode Switch to Hybrid Mode Threaded Mode

Techgsmnet

Cyclone Box all update here

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)